A 4 size photopolymer processing machine 

Designed and manufactured by our company, to produce photopolymer stamps from liquid resin or hard photopolymer plates to be pressed into a matrix board (mold) 

The machine is made of 3  parts : 

Exposure part  (to expose photopolymer material to UV light)

• UV tubes with on/off digital timer including memory 
• vacuum pump to keep  positive and negative films or negative  film and  photopolymer plate  in close contact
• glasses  with closing and calibrating system for liquid photoplymer material processing
• plastic tray with holding system, for liquid resin post exposure
• compressor to pierce air bubbles in liquid resin

Engraving part : (to develop (wash out) photopolymer material

•  all pieces are in stainless steel
•  thermostat for water temperature control
•  timer to start the engraving unit
•  the engraving mechanism is outside water to avoid dirt and jamming problems of the  moving part                               

Drying part (to harden photopolymer material)

• 3 drying compartments
• temperature control by thermostat
• on/off timer         
• 3 drying compartments